XIM Etch-l-M

Out of stock
SKU: 1025-1
Regular price $27.50
Prop 65
WARNING: This product can expose you to [name of chemical], which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Product Description: 1 Qt

Etch-l-M is used as an alternative to the hard work of manual or  machine sanding when the surface must be dulled for paint adhesion. Since Etch-l-M works in minutes, its use can shorten surface preparation time by up to 80%. Etch-l-M leaves a uniform, dull surface without the problem of deep sanding scratch marks that could show through the final finish. It can be reused over and over and cleans up with water. Note: Etching is defined as the chemical corrosion of the porcelain or glass surface. XIM's Etching Cream contains fluoride salts. It can be considered a dilute solution of   hydrofluoric acid and must be handled with care. Hydrogen fluoride is used in the steel industry to pickle stainless steel, aluminum and titanium. It is used in the glass industry as an etchant.

Product Preparation: XIM Etch-l-M Etching Cream is used as is from the container. During storage Etch-l-M can form a gel or separate and crystallize. This is expected. Mix or Stir to a brushable consistency  before using. Note: Keep from freezing. Keep the container tightly closed when not in use. Store at room temperature.

Surface Preparation:

Careful surface preparation and cleaning is the key to good results. Before using the XIM Etching Cream be sure the surface is thoroughly clean and free from all grease, wax, oil, and dirt, mildew, rust and soap residues. Soap residues are not easily seen, but must be removed completely. Clean the surface with a strong abrasive detergent using an abrasive pad or steel wool. Rinse well and allow to dry. Moldy or mildewed surfaces should be scrubbed with a mixture of one quart bleach and three quarts water and then thoroughly rinsed with clean water. Never mix bleach with detergents that contain ammonia. Note: The surface must be free from all contamination for the Etching Cream to "wet" and react with the surface. After removing all contamination, tape off all areas not to be etched. XIM's Etching Cream is an acid and will attack and etch (dull) aluminum and other metals.

How to Apply:

XIM's Etch-l-M Etching Cream is best applied by brush. Apply a medium to heavy quantity of the Etching Cream over the surface to be dulled. It is recommended that you work only in small sections of a few square feet at a time. It is best to work at a temperature of 70 - 75 deg. F. After applying the Etching Cream allow it to work for about 5 minutes. Different types of glass and porcelain require somewhat different etching time frames.